Today:
Tried a dye swirl in clear resin. Mixed 55 grams part A and B in same cup. Then poured into silicone mold. Placed one drop of blue Alumilite dye at one end of the mold. Using a cut down mixing stick, I dragged through the resin pulling lines of dye through the blank. I’m not sure it’ll cure right with a blob of dye not mixed in, but we’ll see. Poured extra resin on HDPE sheet to see what happens.
Upcoming:
Complete build of flat mold out of HDPE.
Challenges:
Use less dye
Update:
Blank did not cure correctly. After hour under pressure blank is very soft. Probably did not mix adequately. Where blob of dye was the blank didn’t solidify.